|
Go back to EPS Epoxy Surfboard Ding Repair Page 3 "Filling the Ding"
EPS Epoxy Surfboard Ding Repair Step 3: "Filling the Ding" Cont.
Step 3: "Filling the Ding" cont. Wear rubber or latex gloves for this procedure. Start by mixing a small amount of epoxy resin in a plastic or similar container. It is important to stir the resin for a couple of minutes to help start the hardening reaction. Mix cavasill into the resin until it no longer droops. See picture below.
EPS Epoxy Surfboard Repair - Epoxy mixed with cavasill
Coat all surfaces which will contact each other and position the foam into place. Remove all the resin that squeezes out between the board and foam piece. This will make it easier to shape the foam later. See Illustrations.
EPS Epoxy Surfboard Ding Repair - Foam Plug Inserted
EPS Epoxy Surfboard Ding Repair - Foam glued in place
Let the piece sit overnight before shaping the EPS foam to the contours of the board.
Go to EPS Epoxy Surfboard Ding Repair Page 5 "Shaping EPS Foam"
|
